Rear bumper protection Volkswagen Crafter 2017-... - type: single pipe (Vendor code: ab002-21207)

Protection material: AISI 304 stainless steel

Design of rear protection: - at the base is a stainless steel pipe with a diameter of 60 mm.

Material of brackets: steel. The mount is designed for this car model. Technological openings of the car (regular places) are used for fastening.

Complete set:

• Rear bumper protection.
• Fastening set (brackets, screws, nuts).
• Installation scheme (for a specialist).

Main advantages: protection of car body parts from damage when driving in reverse, protection from those cars catching up from behind (at low speeds).

Features: installation of rear protection in most cases is carried out on a car without a towing device (towing device).

Installation procedure:

• Attach the brackets to the body and determine the installation locations.
• Install the brackets using the included fasteners.
• Install protection, fasten with screws and nuts.
• Adjust the position of the rear protection in relation to the body.
• Tighten all fastening points.
• Check the tightening of the fastening points. Tighten if necessary